Juniper Networks EX2200 Manuale Utente Scaricare il pdf (Pagina 79)

To mount the switch on four posts in a rack:

1. Attach the front brackets (either the flush or the 2-in.-recess brackets) to the side-rail

brackets using six 4-40 flat-head Phillips mounting screws. See Figure 17 on page 59.

Figure 17: Attaching the Front Bracket to the Side-Rail Bracket

2. Place the switch on a flat, stable surface.

3. Align the side-rail brackets along the side panels of the switch chassis. Align the two

holes in the rear of the side-rail brackets with the two holes on the rear of the side

panel.

4. Insert 4x6-mm Phillips flat-head mounting screws into the two aligned holes and

tighten the screws. Ensure that the two holes in the rear of the side-rail brackets are

aligned with the remaining two holes in the side panel. See Figure 18 on page 59.

Figure 18: Attaching the Side-Rail Bracket to the Switch Chassis

g027017

5. Insert the 4x6-mm Phillips flat-head mounting screws into the remaining two holes

in the side-rail brackets and tighten the screws.

6. Have one person grasp both sides of the switch, lift the switch, and position it in the

rack, aligning the side-rail bracket holes with the threaded holes in the front post of

the rack. Align the bottom hole in both the mounting brackets with a hole in each rack

rail, making sure the chassis is level. See Figure 19 on page 60.

Chapter 8: Installing the Switch

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 175 176

Nessun commento

Juniper Networks EX2200 Manuale Utente Pagina 79